With the continuous development and progress of industrial equipment, many factory enterprises choose some glass palletizing robots to replace manual labour, especially in the express logistics and transport industries. The following are the main features of glass palletizing manipulators.

(1) The structure of the glass palletizing robot is simple and practical. The structure of the whole machine is designed to be simple, reasonable and practical, with a small footprint. Compared with traditional stacker cranes, it can save about 1/3 of the workshop area and the stacking capacity can reach 600-1 200 bags/h. Users can choose according to the actual needs of the enterprise.

(2) High degree of automation. The whole process from bag feeding, turning, coding to palletizing can be fully automatic and continuous. The machine not only has normal start/stop function, but also has self-diagnosis, alarm, printing, communication and fault interlock functions. Software and interfaces for communication with the central control room are reserved.

(3) Stable and reliable operation, low failure rate and high safety. When low inertia and high power operation is adopted, its operation is stable and reliable, and the service life of the equipment components can be extended. When the stacker crane is in normal operation, the process of bag feeding, bag dividing, bag management, bag pushing, coding, bag unloading, empty pallet input and loaded pallet output is carried out according to a set program with display signals. Only the operator can be supervised, and the stacker itself and the people around it have safety guards to ensure safe production.

(4) The components are made of high-strength and lightweight alloys. The service life of the glass palletizing manipulator can reach about 20 years and maintenance costs are relatively low.

The purpose of maintaining the palletising manipulator is to prevent problems and extend the service life of the palletising manipulator. In production, the palletizing robot needs to be properly maintained for the palletizing robot to perform superiorly.

During the operation of a glass palletizing robot, it is inevitable that rubbish or debris will be generated. If not cleaned up in time, it may get stuck in the palletising manipulator, so it is important to clean up the rubbish regularly to maintain the normal operation of the palletising manipulator. Clean up water damage in a timely manner. As the glass palletizing robot needs to operate in a dry environment, it is recommended that it is installed in a place where it will not get wet from rain. If water damage is found on the machine during operation, the machine should be switched off immediately, the power supply cut off and the water damage cleaned up promptly, and the glass palletizing robot started again after the cleaning is completed. Regular lubrication, if the degree of lubrication between the parts is not enough, it will increase the wear and tear, which will easily lead to damage to the parts of each part. Therefore, it is necessary to lubricate the parts regularly, paying special attention to the connection parts of each part.

When lubricating the parts of the palletising manipulator, it is important to note that some parts cannot be lubricated, otherwise problems will occur. At the same time, when oiling the palletizing robot, you cannot add too much oil, if the parts are soaked with too much oil, they will also malfunction. So the amount of lubricant should be controlled, not too much and not too little. What is actually important is to be careful, both in daily maintenance and in industrial production.